3D WALL PANEL INSTALLATION MANUAL

Here are general steps for installing 3D wall panels. Please note that specific instructions may vary depending on the manufacturer and type of panels you have. It's always recommended to carefully read and follow the manufacturer's installation manual for your specific panels.

Materials you may need:
- 3D wall panels
- Adhesive (check the manufacturer's recommendations)
- Measuring tape
- Level
- Pencil
- Saw (if cutting panels is required)
- Putty knife or trowel (for applying adhesive)
- Caulk (for filling gaps, if applicable)

1. Preparation:
   - Ensure the wall surface is clean, dry, and free of any dust or debris.
   - Measure and mark the desired layout of the panels on the wall, using a level to ensure straight lines and uniform spacing.

2. Cutting panels (if needed):
   - Measure and mark the panels for any necessary cuts or adjustments to fit the wall.
   - Use a saw or cutting tool appropriate for the type of panels you have to cut the panels to the desired size/shape. Follow the manufacturer's recommendations for cutting.

3. Applying adhesive:
   - Apply the recommended adhesive to the back of each panel using a putty knife or trowel. Follow the manufacturer's instructions for the type and amount of adhesive to use.
   - Make sure the adhesive is evenly spread across the entire back surface of the panel.

4. Installing panels:
   - Start at one corner of the wall and press the panel firmly against the wall surface, aligning it with the marked layout.
   - Continue installing panels, aligning each one tightly against the previous panel and ensuring levelness and alignment with the marked layout.
   - Gently press and hold each panel against the wall for a few seconds to ensure proper adhesion.

5. Filling gaps (if needed):
   - If there are any gaps between panels or at the edges, use caulk to fill them in, following the manufacturer's recommendations.

6. Finishing touches:
   - Clean off any excess adhesive or caulk from the panels and the wall using a damp cloth or sponge.
   - Allow the adhesive to dry and cure fully according to the manufacturer's instructions before painting or applying any additional finishes.

It's important to consult the specific installation manual provided by the manufacturer of your 3D wall panels for detailed instructions and any additional considerations specific to your panels.